Abstract
Microstructure and shear strength were assessed for a Sn-3.5 wt.%Ag solder joint formed using a laser heat source. A continuous wave Nd:YAG laser was used to make the Sn-3.5 wt.%Ag solder joint. Solder balls of 400 nm diameter were used and the laser beam spot diameter at focus was approximately 120 urn. The UBM (Under Bump Metallurgy) on a FR4-PCB consisted of Cu/Ni/Au from bottom to top with a thickness of 15 μm/5 μm/0.05 um, respectively. In order to position solder balls on the UBM, RMA (rosin mildly activated) type flux for a BGA (Ball Grid Array) was used. Selected optimal conditions were as follows: a laser power of 2W and heating time of 0.3 s, 0.5 s, and 0.7 s; a laser power of 3 W and heating time of 0.1 s and 0.3 s; and a laser power of 4 W and a heating time of 0.1 s. Under all conditions, the shear strengths of the solder joint of (CuNi)3Sn4 at the interface between the pad and solder were larger than 554.37 gf (i.e. the shear strength obtained from hot plate reflow). When the laser power was set at 2 W, the microstructure of IMC (intermetallic compound) was recrystallized regularly due to active convection, which was caused by increased heating time. Under a laser power of 4 W and heating time of 0.7 s, the microstructure was recrystallized irregularly due to violent convection caused by excessive energy input (=laser power (W) xheating time (s)). The IMC layer increased in thickness as a result of increasing the energy input, and was affected by laser power more than by heating time.
Original language | English |
---|---|
Pages (from-to) | 119-123 |
Number of pages | 5 |
Journal | Metals and Materials International |
Volume | 15 |
Issue number | 1 |
DOIs | |
State | Published - Feb 2009 |
Keywords
- Laser soldering
- Lead free solder
- Nd:YAG laser
- Reliability
- Sn-3.5wt.%Ag